Mitsubishi LT-46149 Owner's Manual page 15

2. TV Setup 15
Auto lnput Sensing for CEC-Enabled Devices
When the TV's NetCommand for HDMI feature is enabled,
most CEC-enabled devices are recognized and identified
automatically by the TV. NetCommand for HDMI may
allow you to control functions of a CEC-enabled device.
See Appendix E, "NetCommand HDMI Control of CEC
Devices," page 81.
Setup Procedure for TV Inputs
Power on the TV if not already on.
Connect your devices to the TV, making note
of which TV input is used for each device. See
chapter 3, "TV Connections."
Note: If you wish to use an HDMI device's CEC capa-
bilities, follow the steps in Appendix E.
_ First select a
device type.
Sample Auto Input Sensing screen.
3. When the TV detects a new connection, theAuto
Sensing screen for the connection type will display.
Select the device type if required.
4_
G_
You can perform NetCommand IR "learning" after
selecting the device type or at a later time when
convenient. To perform now, highlight the Learn
icon and press ENTER. See "Initial NetCommand
Setup for Most Devices," page 57 or "Setting Up
NetCommand Control of an A/V Receiver," page 61.
Press EXIT to close the Auto Sensing screen. The
TV will then display the Auto Sensing screen for
the next connection it finds.
After completing Auto Input/Auto Output Sensing,
you may wish to set up or change control of your
equipment using one of the home-theater control
methods described in this Owner's Guide. See
"About Home-Theater Control Systems" on page 17.