Mitsubishi LT-46149 Owner's Manual page 83

Appendices 83
Appendix E: Netcommand HDM! Controlof
Resolving CEC Conflicts, Changing HDMI
Connections, Removing HDMI Devices
Because each manufacturer selects which CEC func-
tions to support, some devices can conflict with other
devices. If control conflicts arise, you can:
= Turn off CEC in the other device's setup menu.
= Turn off TV control of an individual CEC device (see
below).
• Reset TV control of an individual CEC device (see
below).
Turning Off the TV's HDMI Control of an Individual
CEC Device (Figure 5)
1, Press MENU on the TV remote control to enter the TV
Main menu.
Select the Inputs menu using the A Y keys.
3, Select the Inputs > Name menu using the _ key.
4, Highlight the device to remove using the V key and
then the _ key.
With the device highlighted, select Control Off to
turn off the TV's ability to control the device.
6, Press EXIT to clear the menus.
Figure 6. Inputs > Name menu with AVR DVD deleted.
Using NetCommand HDMI Control
As an example of using NetCommand for HDMI
devices, you would press PLAY on the device itself to:
• Turn on the TV if not already on
= Switch to the device (no need to display the Input
Selection menu)
= Begin play of the device
Test your equipment with the TV's remote control to
find out which commands are supported. See the table
below for commands that may be available, depending
on the individual device.
CEC=enabled VCR, DVD, and DVR functions that
may be available:
Figure 5. Inputs > Name menu with HDMI Control for
AVR Tuner turned off
Resetting HDMI Control or Removing an HDMI
Device (Figure 6)
1. Power off the device.
If removing the device, disconnect the HDMI cable.
3. Press MENU on the TV remote control to enter the TV
Main menu.
4. Select the Inputs menu using the A V keys.
Select the Inputs > Name menu using the _ key.
6. Highlight the device to reset using the V key and
then the 11_ key.
Z With the device highlighted, select Delete to reset
HDMI Control.
8, Press EXIT to clear the menus.
If the device is still connected, the Auto Input
Sensing screen will display.
_ 4 I_ ,A,V
OH/X/V
GUIDE
(_ (_ ENTER Digits 0-9,_ F1(content)*
ENTER MENU
(to cancel)
The F1key defaults to work like the device's LIST key.
If you have a CEC-enabied A/V receiver, CEC-enabied
devices connected to the A/V receiver with an HDMi
cable may also be controllable. They can be selected
from the TV's Input Selection menu.
CEC=enabied A/V receiver functions that may be
available:
= Try the MOL, MUTE, and menu-navigation keys.
= To open the A/V receiver menu, follow these steps:
1. While watching TV, press AUDIO.
2. Press A repeatedly until the Speakers option
displays.
3. While Speakers is still displayed, press MENU.
You can use NetCommand IR "learning" to add com-
mands to those supported by CEC. You must first
connect and place IR emitters for the devices.