Hdmi Device - Mitsubishi LT-46149 Owner's Manual

22 3. TV Connections
If your cable box or satellite receiver has an HDM{
output, use the connections for HDM{ devices
described on this page.
Required: RCA component video cables, left/right
analog stereo audio cables.
1. Connect RCA-type cables from the Y Pb Pr outputs
on the device to the Y Pb Pr inputs on the TV main
panel, matching the colored green, blue, and red
connections.
Connect left (white) and right (red) audio cables
from the device to AUDIO L and R on the TV main
panel.
3_
Cable Box or Satellite Receiver Only: Connect
the cable from the outside cable or satellite service
to CABLE IN or SATELLITE IN on the cable box or
satellite receiver. See your device's owner's guide
for instructions and cable compatibility.
Note: To hear digital surround sound, connect the digital
audio output from the device directly to your digital
AN receiver.
Figure 1. Connecting a device with
component video outputs
=
Incoming from =
cable service or =
II
satellite dish _ ....
Required: HDMI-to-HDM{ cable.
Connect an HDM{ cable from the TV main panel to the
HDMI device output. HDM{ devices provide video and
audio through the single cable.
Mitsubishi recommends you use category 2 (high-speed)
HDMI cables to connect HDMI 1.3 source devices.
High-speed category 2 cables bring you the full benefits
of Deep Color and x.v.Color. See "HDMI Cable Catego-
ries," page 9, for more on HDMI cable types.
ii i ii
TV main
panel
Any HDMI
device
Figure 2. Connecting an HDMI device.
Note:
J_
HDMI inputs are SimplayHD" certified for proper
interoperability with other products certified by
Simpiay
TM.