Vcr To An Antenna Or Wall Outlet Cable - Mitsubishi LT-46149 Owner's Manual

3. TV Connections 25
VCR to anAnte nnaor
Wali Outlet Cable
Required: Two-way RF splitter, two coaxial cables, right
and left analog audio cables, either S-video or compos-
ite video cable.
3,
3,
4,
Connect the incoming cable or antenna to IN on the
RF splitter.
Connect one coaxial cable from OUT on the RF
splitter to ANTENNA IN on the VCR back panel.
Connect one coaxial cable from OUT on the RF
splitter to ANT 1 on the TV main panel.
Connect either an S-Video or composite video
cable from VIDEO OUT on the VCR back panel to a
VIDEO composite or S-VIDEO jack on the TV main
panel. Connect only one type of video cable;
S-Video is recommended, if available.
To use the TV speakers with the VCR, connect left
(white) and right (red) audio cables from AUDIO OUT
on the VCR to the associated AUDIO L and R jacks
on the TV main panel. If your VCR is mono (non-
stereo), connect only the white (left) cable.
VCR
TV main panel Incoming
cable
Figure 8. Connecting a VCR to allow recording from an
antenna source.
Required: Two-way RF splitter, three coaxial cables,
right and left audio cables, S-Video or composite video
cable, plus video and audio cables required to connect
the TV to the cable box.
3, Connect the incoming cable to IN on the RF splitter.
Connect one coaxial cable from OUT on the RF
splitter to CABLE IN on the cable box.
3, Connect one coaxial cable from OUT on the RF
splitter to ANT 1 on the TV main panel.
4, Connect one coaxial cable from OUT on the cable
box to ANTENNA IN on the VCR back panel.
Cable
box
5.
Audio and
videofrom
cable box 2.
to TV
=
TV main _nel
=
Incoming j,
cable
Figure 9. Connecting a VCR to a cable box
Connect the cable box outputs to the TV as shown
in one of the options listed below. This connection
allows the TV to receive the best available signal
directly from the cable box.
• Figure 1, page 22: Component video output to
the TV's Y Pb Pr jacks; analog stereo audio to
the associated AUDIO jacks.
Figure 2, page 22: HDMI output to the TV's
HDMI jack.
• Figure 4, page 23: S-Video output to the TV's
INPUT 3 S-VIDEO jack; analog stereo audio to
the INPUT 3 AUDIO jacks.