Mitsubishi LT-46149 Owner's Manual page 31

4. TV Operation and Features 31
receivers, and DVD players. Program the remote
control for your equipment and test the keys. See
Appendix C, "Programming the Remote Control."
25. 1_ (PAUSE}: Freezes a broadcast TV picture from an
antenna source, cable box, or satellite receiver (if
key has not been reassigned for NetCommand use).
Record/Playback Keys
Use any of these methods to enable the recording and
playback commands of the TV's remote control:
• Program the remote control for your DVR, VCR, or
DVD player/recorder and set the slide switch to VCR,
DVD, CABLE/SAT, or AUDIO a s appropriate.
Check HDMI devices for compatibility with the TV's
NetCommand for HDMI feature (see Appendix E).
Perform NetCommand IR "learning" for the device.
24. (_ (RECORD): Records with a VCR or DVR.
25. (_ (PAUSE): Pauses a VCR, DVR, or DVD. See
above for use during TV viewing.
26. _ (STOP): S tops play of a VCR, DVR, or DVD.
27. _ (REVERSE): Rewinds a VCR. Reverse scans a
DVR or DVD.
28. (_ (PLAY):Plays a VCR, DVR, or DVD.
29. (_ (FORWARD): Fast forwards a VCR. Forward scans
a DVR or DVD.
Care of the Remote Control
Use only alkaline batteries.
Be within 20 feet of the equipment.
Do not press two or more buttons at the same time
unless instructed to do so.
Do not allow unit to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicals to clean. Use only a soft,
lightly moistened cloth.
Do not mix old and new batteries.
Low=Battery indicator
If you press a key and the POWER key blinks five times,
replace the remote control's batteries.
ChannelView
TM
displays channel names and program infor-
mation, as sent by broadcasters or your local cable service
provider, for memorized channels on ANT 1 or ANT 2. Listings
may be incomplete. No program information is displayed for
analog channels. An analog channel name is displayed only if
you assigned a name in the Setup > Edit menu (page 47).
To receive ChannelView updates:
Keep the Energy Mode set to Fast Power On
Set the TV clock
Leave the TV powered off for a while each day to
receive updates.
Notes:
- Listings are updated for the digital channel you are
currently watching.
- If the time or date displayed are incorrect, change the
TV's time, time zone, date, or Daylight Savaings Time
settings in the Setup menu.
Using ChannelView
Resetting the Remote Control
If the slide switch is set to TM and the TV does not
respond properly, reset the remote control.
1, Press and hold POWER for several seconds until the
button blinks twice and goes off.
Release the POWER button.
3, Press keys 0 0 9 3 5 and the POWER button will blink
twice when you finish entering the code. While
entering the code, pause for a moment between
each key press to ensure it is recognized.
See ChannelView listings Press GUIDE.
from ANT 1 or ANT 2.
Close ChannelView Press GUIDE o r EXIT.
Scan channels one by one. Press and hold A or V.
Scan channels quickly. Press and hold PAGE i _/V.
Jump to listings fora 1. Enter the channel
specific channel, number (see numbers in
upper left of screen).
2. Press ENTER.
See more of the program Press INFO.
description (if available).
Move navigation to the Press I_.
program listings.
Move navigation to the Press 4.
channel listings.
Tune to the highlighted Press ENTER.
channel.