Maytag MAV-35 User Manual page 11

Cycle Selector Advances Through Off
• Extra rinse is selected.
Fills with the Wrong Temperature Water
• Turn both faucets on fully.
• Make sure temperature selection is correct.
• If Auto Temperature Control is selected, cold water may feel warmer than cold water from the tap (see page 3).
• Make sure hoses are connected to correct faucets and inlet COlmections. Be sure water supply is regulated correctl):
Flush water lhle before fillh_g washer.
• Check the water heater. It should be set to deliver a mh_imum 120 ° F (49 ° C) hot water at the tap. Also check water
heater capacity and recovel T rate.
Disconnect hoses and clean screens. Hose filter screens may be plugged.
End of Cycle Chime Does Not Sound
• When Extended Spin (select models) is not selected, there may be a three-minute delay before chime sounds. This is
normal.
• End of Cycle Chime switch (select models) is set to Lo or Off.
For further assistance contact Maytag Services -''_,Maytag Customer Assistance:
U.S. 1-800-688-9900 or Canada 1-800-688-2002
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
NOTE: In our continuing effort to improve the quality of our appliances, it may be necessary to make changes to
the appliance without revising this guide.
10