Maytag MAV-35 User Manual page 10

Before You Call
Won't Fill
• Plug coM h_to live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control dial to proper cycle and pull dial out to start the washer.
• Turn both faucets on fully:
• Straighten h_let hoses.
• Discocu_ect hoses and clean screens. Hose filter screens may be plugged at the faucet.
• The drah_ hose must be elevated at least to the top of the tub.
Won't Agitate
• Make sure the lid is completely closed.
• Turn the control lolob to proper cycle and pull dial out to start the washer.
• Close lid and pull dial out to start the washer. For your safety; washer will not agitate or spin unless the lid is closed.
• The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop
operations for your safety: Call for service.
• Pauses are normal. Wait and see if file washer will start again.
Won't Spin or Drain
• Straighten
drah_ hoses. Eliminate k£nked hoses. If there is a drah_ restriction, call for sel*vice.
• Close lid and pull dial out to start the washer. For your safety; washer will not agitate or spin unless the lid is closed.
• The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop
operations for your safety: Call for service.
• If the drah_ height is over eight feet, water may not be completely removed.
Load is Wetter than Normal at the End of the Cycle
• The washer is designed to reduce sphl speed if an unbalanced load is detected. This is normal.
• Redistribute the load in the tub and set the washer on SPIN.
• Spin speed may be too slow for load type. Set Wash/Spin speed to Regular/Whites (normal/fast).
Stops
• Turn the control dial to proper cycle and pull dial out to start the washer.
• Close lid and pull dial out to start the washer. For your safety5 washer will not agitate or sph_ Lu_less lid is closed.
• This may be a pause or soak period h_ the cycle. Wait briefly and it may start.
• The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop
fill operations for your safety: Call for service.
Leaks Water
• Make sure water hllet hose connections are tight at faucet and water valve.
• Make sure end of drain hose is correctly hlserted and secured to drah_ facility-
, Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
Is Noisy
• Be sure washer is leveled properly as outl£ned h_ h_stallation manual.
• Weak floors can cause vibration and walkh_g.
• Be sure rubber feet are installed on levelh_g legs.
• Operath_g sounds will val T dependh_g on agitation speed.
9