Grate; Cookware; Cooktop Controls - KitchenAid ARCHITECT KDRS807 Use & Care Manual

_:_te • _:1_:fi _ _ _'__ _ _ _:me_i'
A
¸
_ _ B
..... C
A. Wok supports pointing down (for use
with flat-bottomed cookware)
B. Cooktop grate with InstaWok
TM
Grate
insert (left side of range only)
C. Reversible InstaWok
TM
Grate insert
The TripleTier ®Flame Burner with InstaWok
TM
Grate is a
multifunction burner that produces everything from a rapid boil
down to a low simmer.
The TripleTier ® Flame Burner with InstaWok
TM
Grate is functioned
by a dual valve control knob, which controls 2 separate burners.
See "TripleTier ® Burner with High Power Burner and Low Power
Simmer Settings" in the "Cooktop Controls" section.
The InstaWok
TM
Grate supports 12" to 14" (30.5 cm to 35.6 cm)
Wok pans and can be flipped over to become a flat grate for use
with flat-bottomed cookware.
IMPORTANT: The InstaWok
TM
Grate must be in place when you
are using the TripleTier ® Flame Burner.
To Use the InstaWok
TM
Grate:
1. Check that the control knob is in the OFF position and the
grate is completely cool before handling.
2. Remove grate from cooktop and flip the grate over so that the
wok supports are pointing up.
...... B
'_ C
A. Wok supports pointing up
B. Cooktop grate with InstaWok
TM
Grate insert (left side of range only)
C. Reversible InstaWok
TM
Grate insert
3. Place the wok grate within the supports.
b(!t_?_ :)d b; ,: 'I_;?(]{)
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner Cap Alignment
Always keep the burner cap properly fitted in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
TripleTier_ Flame Burner
B .......... 72 .... ' ...............................E
/
D
A. TripleTier ® flame burner caps
B. Burner base
C. Afignment pins
D. Igniter
E. Gas tube opening
Standard Burner
A ...............
,,ff_jfj_ D
A. Burner cap
B. Burner base
C. Afignment pins
D. Igniter
E. Gas tube opening
Gas tube opening
Gas must flow freely throughout the gas tube opening for the
burner to light properly. Keep this area free of soil and do not
allow spills, food, cleaning agents or any other material to enter
the gas tube opening. Avoid spillovers by always using a burner
cap.