Electronic Oven Control; Display; 13. Start/Enter; 14. Off/Cancel - Kenmore 665.92022 Use & Care Manual

1. RECIPE RECALL
TM
2. Display
3. Clock
4. Timer
5. Cooktop Lockout
ELECTRONIC OVEN CONTROL
"_j/• i i
7 8 9
2
®
C001( I_Y
lIME s'r_'r
\
10
3 4
HOUR MIN
11 12
5 6
START OFF
r,_,xclp.
J
13 14
6. Oven Light/Oven Lockout
7. Oven Selector
8. LOGI-CLEAN
TM
Self-Clean
9. Temperature Setting
10. Timed Cooking
11. Hour
12. Minute
13. Start/Enter
14. Off/Cancel
m
Display
When power is first supplied to the appliance, everything on the
display will light up for 5 seconds. Then the time of day and "PF"
will appear on the display.
Any other time "PF" appears, a power failure occurred. To
remove "PF" and to reset the clock, press OFF/CANCEL
When the oven is in use, this display shows time, temperature
and what command pads have been pressed.
When the oven is not in use, the display will show the time of day.
The START/ENTER pad begins any oven function except the
Timer. If not pressed within 5 seconds after pressing a pad,
"START?" will appear on the display as a reminder. If not pressed
within 5 minutes after pressing a pad, the display will show the
time of day and the programmed function will be cancelled.
The OFF/CANCEL pad stops any oven function except for the
Clock, Timer and Cooktop or Oven Lockouts.
After pressing OFF/CANCEL, the display will show the time of
day or, if the minute timer is also being used, the time remaining.
This is a 12 hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK.
2. Press the HOUR/MIN "up" or "down" arrow pads until the
correct time of day shows on the display.
3. Press CLOCK or START/ENTER.
Tones
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheated
• Function has been entered
Three tones
• Invalidpad press
Four tones
• End-of-cycle
• Reminder, repeating each minute after the end-of-cycle tones
Error Tones
Error tones indicate a problem with the electronic oven control.
An error code will appear in the display.
Tone Volume
The volume can be adjusted between high and low.
To Change: Press and hold DELAY START for 5 seconds. A short
tone will sound and either "Snd HI" or "Snd Lo" will appear on the
display. Press and hold DELAY START again for 5 seconds to
change to desired setting.
To remove "Snd on", "Snd OFF", "rEP on", "Snd HI" or "Snd Lo"
press any pad, and the time of day will appear on the display.
Reminder Tones
Reminder tones are four 1-second tones which indicate that the
set time has expired for a timer or a timed oven control function.
Timer
To Turn Tones Off/On: Press and hold SET/OFF for 5 seconds. A
short tone will sound and "rEP OFF" will appear on the display.
Repeat to turn back on.
if,
11