Table of Contents
Advertisement
(4)
Writing information on option label
To allow the options installed in the disk array unit to be found by external view, the label indicating
the options available for the installation is put on the disk array unit.
If a disk drive is added, write down the last three digits of model number and a check mark at the
corresponding field on the label to indicate the addition as shown in the figure below.
Enter the last three digits of model number
Note: The figure above indicates that a single NF1400-SM423E is installed at location '03' in NF1400-SR40E.
If NF1400-SM414E is additionally installed in NF1400-SR40E, write down check marks at the locations in
which the disk drives are installed, which appears in the area to the right of the model number field.
If the model number of disk drive additionally installed does not appear in the model number field, enter the
last three digits of model number in "NF1400-SM
When installed NF1400-SM413E, enter '413'
When installed NF1400-SM414E, enter '414'
When installed NF1400-SM415E, enter '415'
When installed NF1400-SM422E, enter '422'
When installed NF1400-SM423E, enter '423'
When installed NF1400-SM424E, enter '424'
Then, write down a check mark at the location in which the disk drive is installed, which appears in the
area to the right of the model number field.
If disk drives are installed at locations '03' and '04,' write down check marks at the '03' and '04' fields.
Write down a check mark as shown in the figure.
(E)" field as follows.
6-5
Advertisement
Table of Contents
