NEC S1400 NF1400-SR40E User Manual page 56

(2) Connection of power cords
Insert the receptacle of the power cord provided with the disk array unit into the power plug on the
power supply. Secure the power cord with the power cord stopper.
NOTE:
above, connect the power cords according to the procedure
below.
As shown in the left figure below, open the AC cable clamp, fit the power cord into it, and
lightly lock the clamp.
As shown in the right figure below, move the clamp in the direction indicated by the arrow,
and firmly secure the clamp near the root of the plug.
NOTE:
come off. To prevent this problem, firmly secure the AC cable
clamp near the root of the power cord.
(Power cord disconnection procedure)
As shown in the figure below, push the catch on the AC cable clamp to release the lock. After
releasing the lock, remove the AC cable clamp from the power cable.
If the lock of the power cord is different from the figure
Fit
AC cord
Spread
Clamp section
If the clamp is loosely locked, the power cord may
Cable clamp
Catch
5-13
Release