Table of Contents
Advertisement
5.5
Connection of Power Cords
Do not concentrate power cords only to some AC outlets. If so, fire may occur.
Do not connect the plug of a power cord to an AC outlet with a wet hand. If so,
you may be electrically shocked.
Do not put a heavy substance on a power cord. If so, the coating of the power
cord may be broken, fire may occur, and/or you may be electrically shocked.
Be sure to use the power cords provided with the disk array unit.
Connect the power cords in the following procedure.
The disk array unit has the redundant power configuration to prevent the entire unit from shutting
down due to a single failure. Therefore, connect two power cords to the power supplies when
operating the disk array unit.
(1) Check of power supply
Check that the power switch on the disk array unit and those on the host system are all set to OFF.
WARNING
OFF
5-12
ON
Advertisement
Table of Contents
