Important Note On Threading; Changing Spools With The Machine Threaded - Pfaff creative 4874 Instruction Manual

Note: Even when the looper
threads break, you must
remove the threads from the
eye of the needle, rethread
the looper threads, and then
rethread the needles.
2-20

Important note on threading

Always thread the needles last, so the
needle thread pass over the looper thread
as shown in Fig. 2 and not under it as in
Fig. 1. Otherwise the thread may break or
stitches may be formed incorrectly.
Changing spools with the machine
threaded
Cut the spool threads close to the spool
and position new spools. Tie the thread
that is still in the machine to the threads
on the new spools and unthread the
needles. Press the tension release button
(10) (see page 3-4) and pull the needle
threads until the knots have advanced
through the last thread guide before the
needles. Cut the knots off and thread the
thread through the eye of the needle. You
can pull the looper threads all the way
through the looper eyes and place them to
the left under the presser foot.