Note: The detachable thread
stand is required for stitch
programs 21 – 30.
2-4
Detachable thread stand
Insert the top catches of the detachable
thread stand (27) into the top slots on the
rear cover and press the bottom portion of
the stand against the cover.
Push the detachable thread stand to the
right as far as it will go.
Place one foam pad (52) and one cone
holder (51) on each of the spool pins (50).
To remove, push the thread stand to the
left and pull up.
Thread stand
Before placing the spools, you must slide
the thread stand (49) back as far as it will
go.
Place one foam pads (52) and one thread
cone holder (51) on each of the spool pins
(50).
Thread guide slide
Pull the thread guide (28 and 44) up as far
as it will go.
To assure optimum thread feed, the two
top slide sections must be rotated slowly
until you hear their locking pommels click
into place.