Jenn-Air JXD7836BS0 Use & Care Manual page 6

Product Dimensions
A
G
I
I
I
I
I
A. 35_" (89.5 cm)
B. Infrared remote sensor
C. 291_,, (76.0 cm)
D. 33" (83.8 cm) min.,
38V2" (97.8 cm) max.
E. 9¼" (23.5 cm)
F. Centerline of bottom vent area
G. 39 ¼" (99.7 cm)
H. Remote up/down switch
connector
I. 403/4'' (103.5 cm)
K
A. 18_/2 ' ' (47.0 cm)
B. 2V2"(6.4 cm)
C. 10_" (26.4 cm)
D. 7 z_'' (20.0 cm)
E. 3" (7.6 cm)
F. _/2" ( 1.3 cm)
G. l _" (3.3 cm)
H. l _" (4.1cm)
I. 4_" (11.7 cm)
J. 9¼" (23.5 cm)
K. 26" (66.0 cm)
typical, both sides
L. 2 z_ '' (6.2 cm)
M. _" (0.S cm)
Cabinet Dimensions
A. 39z_ '' (100.2 cm)
B. 61_ '' (17.0 cm)
C. 2" (5.1 cm) min. to back wall
D. Minimum countertop depth. See IMPORTANT*.
E. 3F2" (8.9 cm) min.
F. Centerline of cooktop and downdraft ventilation system
*IMPORTANT: Cabinet and countertop depths are determined by
the cooking appliances to be used with this downdraft vent
system.
NOTES:
• See appliance manufacturer's installation instructions for
cooking appliances dimensional cutout requirements.
• Exterior-mounted blower systems connect with 10" (25.4 cm)
round vent. The cutout locations for this vent system will
depend upon your specific installation.
• Use the dimensions for the vent system cutout location that
apply to your installation.
Countertop Cutout Dimensions
IMPORTANT: Countertops with a bull-nosed front edge are not
recommended for these installations.
Cabinet and Countertop depths requirements may be deeper
than 38" (96.5 cm). This depth is determined by the cooking
appliances being installed with this downdraft vent system.
To avoid mistakes, it is recommended that the cooktop and vent
cutouts be drawn on the countertop before making any cutouts.
See cooking appliance Installation Instructions for complete
cutout dimensions, location dimensions and installation details.
A C
%
%%,,
II
A. Cooktop
B. Downdraft vent system
C. Countertop
D. Back wall of cabinet
f D
S ¸
6