Jenn-Air JXD7836BS0 Use & Care Manual page 15

Remote Control Operation
A. Power on/off D. Fan auto off
B. Up/down E. Fan speed decrease
C. Maximum fan speed E. Fan speed increase
NOTE: The infrared remote (IR) sensor is located on the top right
surface of the ventilation system top frame. When the remote
communicates with the sensor, there is an audible signal.
Power On/Off
• When hood is in the down position, the On/Off button
raises hood, turns on the lights and sets the fan speed to
1 (minimum). One speed indicator light comes on.
• When hood is in the raised position, the On/Off button
turns the blower and speed indicator light off.
Up/Down
• The up/down button raises and lowers the hood. The
lights and fan turn Off in the down position.
Fan Speed Increase
• Increases fan speed from speed 1 to speed 4. The
number of fan speed indicator lights increases as the fan
speed increases.
Fan Speed Decrease
• Decreases fan speed from speed 4 to speed 1. The
number of fan speed indicator lights decreases as the fan
speed decreases.
Maximum Fan Speed
• Turns the fan directly to speed 4 without stepping through
speeds 1-3 and turns the indicator lights on to the
maximum number.
Auto Off (fan only)
• Steps down (decreases the fan speed) through the
speeds to Off (33 minutes to Off from maximum speed).
The left indicator light blinks and the fan speed indicator
lights turn Off as the fan speeds change.
• Steps down from speed 4 to speed 3 - (3 minutes).
• Steps down from speed 3 to speed 2 - (5 minutes).
• Steps down from speed 2 to speed 1 - (10 minutes).
• Steps down from speed 1 to OFF - (15 minutes).
NOTE: If the remote stops functioning properly, remove the
batteries for 1 minute and then reinstall the batteries. (See
"Changing the Remote Batteries" in the "Vent System Care"
section.) This will reset the remote to its original settings.
If the remote still does not function properly, change the
batteries. The remote requires 2 - CR2032 batteries.
15