Fedders 23-23-0355N-002 Installation & Operation Manual page 7

23-23-0355N-002
Mechanical Control (Cooling Only)
Mechanical Control (With Heat)
Cooter
ee ® o,_
® @ @ // o
(_ Wait 3 Minutes Before Restartin_
Q Thermostat
Master Control
_ Caution:
If air conditioner is shut off,
wait a minimum of three
minutes before restarting.
'" QPERATIDN -'_
MECHANICAL CONTROLS)
Mechanical Control Panel
Control Function
Open Vent Door - When the vent door is open it allows for fresh air to circulate and
for stale air to be removed from the room, Maximum air circulation and cooling occur
when the vent door is CLOSED,
Master Control - The Master Control turns the unit off and on, It is also used to select
the desired function of the unit such as High Cool, Medium Cool, Low Cool, High
Fan, Medium Fan (on some models) or Low Fan, When one of the fan functions is
selected, the unit will only circulate the existing room air, The unit will only cool the
air when one of the Cool functions is selected,
Thermostat - The Thermostat Control adjusts the sensitivity of the unit thermostat,
which regulates the room temperature by automatically turning the compressor on
and off, The cooler the setting, the cooler the room temperature will be,
Cooling Operation
1, Close the vent door,
2, Turn the Thermostat Control to
"Cooler",
3, Turn the Master Control to
"High Cool",
4, If the room becomes to cool for
comfort, turn the Thermostat
Control counterclockwise until the
compressor turns off
(air-circulating fan will remain in
operation),
5, When the desired comfort level is
reached, the Master Control may be
turned to "Low Cool",
6, To turn off unit or in the event of a
power interruption, turn the Master
Control to OFF,
Heating Operation
(Heating Models Only)
1 Close vent door
2, Turn Thermostat to "Warmer",
3, Turn Master Control to High Heat,
4, If room becomes too warm for comfort,
turn the Thermostat clockwise until the
heating elements turn off (air circulating
fan will remain in operation), The
temperature will be automatically
maintained, Further adjustment of
Thermostat may be needed to reach
desired comfort level,
5, When the desired comfort level is
reached, the Master Control may be
turned to Low Heat,
6, To turn unit off, or in event of power
interruption, turn Master Control to Off,
Air Circulation Without Cooling or Heating
1 ,Close vent door, 2, Turn Master Control to HI FAN,
Exhaust Operation Without Cooling or Heating
1 ,Open vent door, 2, Turn Master Control to HI FAN,
Directing Airflow
Unit is engineered with adjustable louvers to direct discharge airflow, Louvers are
manually adjusted by moving levers in direction of desired airflow,
Q Filter @ Louvers Q Vent door
Cleaning the Air Filter
Clean the filter every two weeks
1. Turn Master Control to OFF,
2. Remove the air filter by opening the air intake panel on the decorative front and
pull it out of the unit,
3. Wash in hot soapy water, rinse and shake dry,
4. Replace the filter, with the front of the filter toward you,
5. To dry the filter thoroughly, run your unit for a few minutes, Remember, only a
clean filter works properly and delivers top efficiency at every setting,
_ ote: Failure to keep air filter clean will result in poor air circulation.
DO NOT operate without filter. This can render the unit inoperative.
Proper use and care of your air conditioner will help ensure longer life of the
unit. It is recommended to annually inspect and clean the coils and condensate
water passages. Expense of annual inspection is the consumer's responsibility.
7