Fedders 23-23-0355N-002 Installation & Operation Manual page 6

OPERATION _']
ELECTRONIC CONTROLS
Electronic Control Panel
Power Control
The Power Control turns the unit on and
off.
Set Temperature/
Timer Oisplay
Shows the set temperature when the unit
is in operation and hours when the timer
is being set. THE TEMPERATURE
DISPLAY ONLY SHOWS THE SET
TEMPERATURE, NOT THE ACTUAL
ROOM TEMPERATURE,
Temperature/ Timer
Hour Controls
These buttons are used to raise or lower
the set temperature in increments of 1°
from 66°F to 88°F. By depressing both
buttons at once, the display will toggle
between Celsius and Fahrenheit. When
the timer is being set, these buttons are
used to change the hour setting in
increments of 1 from 00 to 24.
Mode Control
A green light will indicate which mode is
currently being utilized.
Cool Mode-
The unit will circulate and cool the air.
Heat Mode (Heat Models Only) -
The unit will circulate and heat the air.
Heater Safety Feature- When heater is
powered off, low fan will automatically stay
on and run for 60 seconds to ensure the
removal of residual heat, meanwhile, the
Low Fan LED blinks until the low fan stops.
Fan Mode-
The unit will only circulate the air.
Energy Saver Mode -
(The energy saver mode is designed to
operate with Cool mode only). The fan
will switch from the set fan speed to Low
whenever the compressor turns off in
response to the thermostat. When the
compressor cycles back on, the unit will
return to the original fan setting. Speeds
will change automatically as the
temperature in the room changes.
Fan Speed Control - High,
Medium, Low and Auto
The settings are adjusted with the Fan Speed Control, each time the button is
depressed it changes the setting. A green light will indicate which setting is currently
being used.
When the Auto feature is selected while the air conditioner is in the Cool or Heat
mode, the fan speeds will change automatically as the temperature in the room
changes. In Cool Mode when the room reaches 7 ° or more above the set temperature
High Fan will be used, 4 ° or less above the set temperature will use Low fan. In Heat
Mode when the room reaches 7 ° or more below the set temperature High fan will be
used, 4 ° or less below the set temperature will use Low fan. At all other times the fan
will use Medium fan.
Timer Control
(The timer can be set to either turn the unit on or off.)
To automatically START the unit using
the Timer mode:
1. Push the timer button while the
power is OFF. The display will read 00.
Adjust the display to show the desired
number of hours before START-UP using
the Temperature/Timer adjustment
arrows.
2. The display will show the amount of
time, in hours, remaining until START-UR
3. To exit Timer mode, push the Timer
button.
4. A green light next to the Timer
button indicates that the timer is set.
To automatically SHUT-DOWN the unit
using the Timer mode:
1. Push the timer button while the
power is ON. The display will read 00.
Adjust the display to show the desired
number of hours before SHUT-DOWN
using the Temperature/Timer adjustment
arrows. (The display will automatically
return to the set temperature after 10
seconds.)
2. To display the amount of time left
until SHUT-DOWN, push the Timer
button once.
3. To exit Timer mode, push the Timer
button twice.
4. A green light next to the Timer
button indicates that the timer is set.
Air Conditioner Remote Control
The functions work the same as your air conditioner's touch controls.
CAUTION
Batteries may become hot, leak, or explode due to improper use.
• Do not install the batteries with the polarity (+/-) reversed.
• Do not subject batteries to fire or high temperatures.
• Do not attempt to recharge, short, or disassemble.
Keep batteries and other things that could be swallowed away from young
children. Contact a doctor immediately if an object is swallowed.
23-23-0355N-002
Electronic Control (Cooling Only)
• Cool
• Energy Save
• Fan
Built in 7hree Minute Cooling Delay
Electronic Control (Heat/Cool)
_gh ;uto
o_ Med _ _Low
Q Heat
0_ O Cool
• [nergy Save
_Fan
Built in Three Minut_ Cooling Delay
Temperature/Timer Display
Temperature/Timer Adjustment
Timer On/Off
Fan Speed Control
Mode Control
Power Control
_ he heat from this unit is designed
only as a supplemental heat
source in addition to
regular heating systems.
Battery Installation
_ t$
6