Starting/Canceling A Function; Ultrabake Baking/Roasting - Kenmore SELECT CLEAN 665.75832 Use And Care Manual

STARTING/CANCELING A FUNCTION
After setting a function, you must press START/ OFF/CANCEL will cancel any function except the
ENTER to start the function. If you do not Clock, Timer, or Oven/Cooktop Lockouts.
press START/ENTER within 5 seconds of When you press OFF/CANCEL, the display
setting, "START?" will show on the will show the time of day or, if the minute
display as a reminder. If you do not press timer is also being used, the time remaining.
START/ENTER within 5 minutes of setting, the time
of day will appear. You must reset the function and
press START/ENTER.
ULTRABAKE
TM
BAKING/ROASTING
Your oven is designed with the ULTRABAKE
TM
IMPORTANT:
enhanced baking system to constantly monitor
oven temperature. The bake burner will cycle, as
needed, to maintain the desired temperature. This
feature is automatically activated when the oven is
in operation.
• When using the oven for the first time, it is
necessary to light the surface burners first to
purge air from the gas line.
• Do not try to light the oven burner during a
power failure.
• Never place food or cookware directly on the
oven door or the oven bottom.
1.
Place the STURDIGLIDE
TM
rack(s) where you
need them in the oven. For more information, see
the "Positioning racks and pans" section, p. 9.
3. Set the temperature (optional). PRESS YOU SEE
Do this step if you want to set a temperature _.MP
other than 350°E Press TEMP (A) or (Y) pad(s)
to raise or lower the temperature in 5°F amounts.
Use these pads until the desired temperature
shows on the sma d sp ay.
(example for bake at 375°F)
continued on next page
15