The Electronic Oven Control - Kenmore 665.75775 Use & Care Manual

THE ELECTRONIC OVEN CONTROL
UltraBake
TM
Kitchen timer set and
electronic display off pad (pp. 12, 131
TEMP
SELECTOR NI @
Clock and
KITCHEN TIMER
manual oven
light pad
(pp. 12, 36)
TIMED OVE N HOUR MIN
COOK START STOP
T'ME I T,ME I T'ME
Oven selector Temperature
pad pad
(bake, p. 14; (pp. 14, 16,
broil, p. 17; 20, 22)
clean, p. 28)
Timed oven Hour Minute Start/enter and
control pad pad pad off/cancel pad
(pp. 20-24) (pp. 12, 21, 22, (pp. 11, 12, 13,
23, 28, 29) 15, 16, 17, 21,
28)
• When you first plug in the range, everything on
the display will light up for 1 to 2 seconds, then
a time of day and "PF" will appear on the
temperature display. Press OFF/CANCEL to clear
"PF" from the display, if, after you set the clock
(see "Setting the clock," p. 12), "PF" again
appears on the display, your electricity was off
for a while indicating a Power Failure. Reset the
clock, if needed.
• When you are not using the oven, the control is
an accurate clock.
• When you are using the oven or kitchen timer,
the display will show times, temperature settings,
and what command pads have been pressed.
• When showing the time of day, the display will
show the hour and minutes.
• When you are using the kitchen timer, the display
will show minutes and seconds in the following
sequence:
- For settings from 1 to 59 minutes, the display
will count down each second.
- For settings one hour or over, the display will
count down each minute.
• When you are using cook time and/or stop time,
@ _ thedisplaywillshowhours
and minutes or minutes and
seconds.
The control lock lets you shut down the control
panel command pads. The control lock comes in
handy when you want to prevent others from using
the oven.
NOTES:
• You can only use the control lock when the oven
is not in use or the control has not been set.
• Set the control lock when cleaning the control
panel to prevent yourself from accidentally turn-
ing on the oven.
• The control lock will stay on even after a power
failure.
To lock the control panel:
Press and hold START/ENTER for 5 seconds. You
P,,sEc will hear a single tone and "Loc" and _1
will appear on the temperature display.
When the control is locked, "START?" will
appear on the display and 3 tones will
sound if you press any command
pad other than clock or timer set.
To unlock the control panel:
Press and hold START/ENTER for 5 seconds. You
P,,sEc will hear 3 t_nes followed by a single tone.
"Loc" and [] will disappear from the
temperature display.
11