Table of Contents
Advertisement
Additional
information
Symptom
Possible
cause
Remedy
No picture is displayed
on the monitor.
Connection
of video cable is incorrect.
Connect the cable correctly.
No picture is displayed
on the monitor
or
the screen is blurred or divided
into two
parts.
A picture is noisy or blurred.
A picture does not fit the television
screen.
The upper and lower parts of the
preference
display
are cut off when using
wide-aspect
TV.
Input selection
of TV is incorrect.
Disc is not playable.
The unit is in the progressive
scan mode
(i.e. the PROGRESSIVE indicator
is lit)
though
it is connected
to a TV via the
VIDEO or S-VIDEO jack.
The unit is connected
to a VCR directly
and
the copyguard
function
is activated.
With some discs, a picture
may be blurred
when setting
"PROGRESSIVE
MODE" to
"FILM" or "AUTO".
MONITOR TYPE is not correctly
set.
Television
is not correctly
set.
It depends on the setting on the TV.
Select correctly.
Use a playable disc. (See page 4.)
Set the Scan mode selector
on the rear
panel to "480i", or set it to "REMOTE" and
make the Progressive
scan mode inactive
by using the VFP-PROGRESSIVE
SCAN
button
(see pages 7 and 8).
Connect the unit so that the picture signal
flows directly
to the TV.
Set "PROGRESSIVE
MODE" to "VIDEO".
(See page 49.)
Select monitor type correctly. (See page 49.)
Set the television
correctly.
Adjust
the TV screen using the control
on
the TV.
Symptom
No audio is reproduced.
No audio is reproduced
when playing
back
a DVD disc recorded
with
High-sampling
(88.2 kHz or more) linear PCM audio using
the DIGITAL OUT jack.
Audio volume
is low when playing
back the
unit, compared
with the TV or VCR.
Possible
cause
Connection
is incorrect.
Input selection
of amplifier
is incorrect.
The audio signal is not derived from the
unit's DIGITAL OUT. (See page 50.)
The audio level recorded
on a DVD VIDEO
is lower, compared
with TV broadcasting.
Remedy
Check the connection.
Select correctly.
Use AUDIO OUT when playing
back such
discs.
Turn up the volume
of the TV or amplifier/
receiver.
Note that you should turn down the volume
before switching
back to TV broadcasting,
to prevent outputting
the sudden
big
sound.
Sound is distorted
or noise is generated.
Disc is dirty.
Wipe the disc surface. (See page 5.)
60
- Quick Links:
- Connections
Hide quick links:
Advertisement
Table of Contents
