Advertisement
DIAGRAM OFTHECONSOLE
Monitor D isplays
[nj ry. • Do not st_r_d o_, walking
belt when
starting
treadm
II,
• Read User's Ma
L_al _nd follow
wambgs
and
operat ng instn;ctions,
• Keep flids
off electlonie
console,
Control __CIiD
i
Speed
--
--_'-'_J_""-.-_.i_
Key
CAUTION:
Before operating the
• Adjust the speed in small increments.
console, read the following
precautions.
• The training zones marked beside the speed
• Do not stand on the walking belt when turning
control are general guidelines only. See page
on the power.
14 for more information.
• Always wear the clip (see the drawing above)
• To reduce the possibility of electric shock,
while using the treadmill. When the key is re-
keep the console dry. Avoid spilling liquids on
moved from the console, the walking belt will
the console. Use only a sealable water bottle.
sto p.
BATTERYINSTALLATION
The console requires three "AA" batteries (not
included). Alkaline batteries are recommended.
To install batteries, open the battery cover under the
console as shown below. Press three batteries into the
battery com-
partment.
Make sure
Battery
that the neg-
Cover
ative (-)
ends of the
batteries
are
touching
the
springs.
Close the
_ries
battery cover.
STEP BY STEP CONSOLE OPERATION
If there is a thin sheet of clear film on the face of the
console, remove it.
Before operating the console, make sure that the power
cord is properly plugged in. (See HOW TO PLUG IN
THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps on page 9 to operate the console.
Advertisement
