Goldstar GCV1946M Owner's Manual page 13

BASIC TV OPERATION
Memorizing the Channels by AUTO PROGRAM
AUTO PROGRAM searches and memorizes all the active channels in your area.
,
.
Press the TV/AV button until a channel number is displayed
on the screen.
Press the MENU button until the picture menu is displayed as
shown right.
* INPUT
AUTO CH SEARCH
CH ADD/ERASE
CAPTION
LANGUAGE
AUTO REPEAT
Use _ and •
.
Press the CHANNEL • or • button until AUTO CH
SEARCH is indicated as shown right.
INPUT
• RUTO CH SEARCH
CH ADDIERRSE
CAPTION
LANGUAGE
AUTO REPEAT
Use _ and •
,
Press the • (ENTER) button.
The AUTO PROGRAM starts now.
The numbers of the channels being searched appear on the
left lower side of screen.
AUTO CH SEARCH
AIR 02
Notes: • To stop AUTO PROGRAM, press the • (ENTER) button.
Only the channels searched up to that time are memorized.
• To memorize the CATV channels by AUTO PROGRAM, select CABLE mode (refer
to "Selecting the Input Signal") and repeat above process 2-4.
Adding or Delecting Channels by MANUAL PROGRAM
1. Repeat above process 1-2.
2. Press the CHANNEL • or • button until CH ADD/ERASE
is indicated as shown right.
3. Press the • (ENTER) button.
The CH ADD/ERASE mode is displayed as shown right.
4. Select the channel number you want to add or erase with the
CHANNEL •/• buttons.
5. Press the VOL • or • button to select ADD or ERASE.
6. Press the • (ENTER) button.
INPUT
AUTO CH SEARCH
CH ADD/ERASE
CAPTION
LANGUAGE
AUTO REPEAT
Use _ and •
CH ADD/ERASE
AIR 25 ADD
Use 4P and •
13