Introduction; Activating The Model 3196Rc; De-Activating The Model 3196Rc - Patton electronics 3196RC User Manual

Idsl tdm-digital access concentrator (t-dac)

Hide thumbs Also See for 3196RC:

Table of Contents

Model 3196RC T-DAC User Manual

Introduction

This chapter describes how to start up and power down the Model 3196RC.

The Model 3196RC is activated by completing the procedures in chapter 2,

page 24 and chapter 3,

the procedures in those chapters.

The Model 3196RC is designed for unattended operation. Once the Model 3196RC has been installed and

configured, no further operator action is required under normal conditions.

Perform the following procedure to deactivate the Model 3196RC.

Note

1. Unlock the handles on the front of the 3196RC by pressing the red button on each handle. The button

immediately activates the switch (turning it to an open position), while the button itself remains depressed.

Remove the blade by pushing the handles outwards.

2. Remove the Model 3196RC from the rack chassis. Place the blade on an anti-static surface.

3. Remove the rear blade from the rack chassis. Place the blade on an anti-static surface.

Introduction

"Configuring the T-DAC for operation"

Be sure to wear an anti-static strap to prevent electrostatic damage to

the blade.

4 • Operation and shutdown

"Hardware installation"

on page 35. To activate the 3196RC, follow

Table of Contents