Table of Contents
Advertisement
Model 3196RC T-DAC User Manual
To activate remote loop, do the following:
1. Go to the iDSL page and find the port to be placed under loopback.
2. Locate the
Test Mode
3. Go to the bottom of the screen and click on the
be highlighted in blue.
To deactivate the loop mode, use the
ton. The port field should be highlighted green when the port returns to data mode.
Line Loop
The line loop, initiated from the 3196RC, tests the DSL link between a 3196RC DSL port and the CPE. When
a DSL port is placed on line loop, data transmitted by the CPE is looped at the 3196RC port (see
1092
Note
To activate line loop on a DSL port, do the following:
1. Go to the iDSL page and find the port to be placed under loopback.
2. Locate the
Test Mode
3. Go to the bottom of the screen and click on the
highlighted in blue.
To turn off the loop mode, use the
ton. The iDSL port field should be highlighted in green when the port returns to data mode.
Basic iDSL and T1/E1 test modes
drop down menu and select
Test Mode
drop down menu, select
DSL
Figure 54. Line Loopback
Line Loopback testing is intended for troubleshooting an iDSL con-
nection in consultation with an end-user connected to the CPE. The
CPE does not notify users when the T-DAC's iDSL port enters line
loopback mode.
drop down menu and select
drop down menu, select
Test Mode
5 • Troubleshooting and maintenance
remoteLoop(2)
.
button. the DSL port selected for remote loop will
Submit
none(0)
3196RC
lineLoop(3)
.
button. The port selected for line loop will be
Submit
none(0)
and click on the
Submit
figure
54).
and click on the
Submit
but-
but-
76
Advertisement
Table of Contents
