Table of Contents
Advertisement
Model 3196RC T-DAC User Manual
19. Press the left-arrow cursor key until the TOP LEVEL MANAGEMENT window displays.
20. Select
a
for Home, then press
21. Under the Current Status page, type
figuration.
This completes the initial configuration of the Model 3196RC. The next steps in configuration will be done
using your Web browser connected via Ethernet to the 3196RC.
Using a browser to complete Model 3196RC configuration
This section describes the following procedures:
•
Displaying the T-DAC home page (see
page 41)
•
Setting static connections with DS0 mapping (see
•
Setting the system clocking parameters (see
•
Configuring the IP default gateway (see
•
Configuring the T1/E1 WAN links (see
"Configuring line settings and signaling for T1"
Displaying the T-DAC 3196RC web administration pages
Do the following:
1. Connect your PCs Ethernet connection to the Ethernet LAN.
2. Connect the 3196RC's T-DAC 10/100 Ethernet connection to the Ethernet LAN.
3. At your PC, open a Web browser session. In your browser's URL/address field type the IP address of the
Model 3196RC (for example, if the Model 3196RC's IP address 123.124.221.10, you would type
123.124.221.10
in the browser's URL/address field). If you do not have an IP address in your TDAC, refer
to
"Initial configuration through the RS-232 control port"
4. A login prompt will appear. In the username field type
. In the password field type
Password field
Using a browser to complete Model 3196RC configuration
<Enter>
.
(store Config(1)) to save the changes you have just made to the con-
1
"Displaying the T-DAC 3196RC web administration pages"
"Configuring the DS0 mapping"
"Configuring the system clocking parameters"
"Configuring the default gateway"
"Configuring line settings and signaling for E1"
on page 60)
then press
superuser
3 • Configuring the T-DAC for operation
on page 44)
on page 37.
superuser
then press
<Tab> to move the cursor to the
.
<Enter>
on
on page 47)
on page 45)
on page 57 or
41
Advertisement
Table of Contents
