Table of Contents
Advertisement
Model 3196RC T-DAC User Manual
•
Hard Reset—this button (see
select Hard Reset, the T-DAC confirms that you want to execute this command. Then, the T-DAC will
disconnect all current sessions, re-initialize the interfaces, and re-load configuration parameters from
FLASH.
•
Set Factory Default Configuration—this button (see
loads the factory default parameters into FLASH memory. The factory default settings will not execute on
the Model 3196RC until it is re-booted by doing a Hard Reset.
Note
Configuring the default gateway
The default gateway IP address, if defined, is used solely for managing the 3196RC remotely via the Ethernet
port. The 3196RC does not transmit or receive user data nor any other traffic via the default gateway IP
address or the Ethernet port.
Do the following to add the default gateway:
1. On the 3196RC Configuration Menu, click the IP hyperlink to open the IP Configuration page.
2. Click the Routing Info hyperlink to open the IP Routing Information page
3. The existing route you see in the table is the LAN IP address you assigned to the 3196RC during initial
configuration through the RS-232 control port, earlier in this chapter.
Using a browser to complete Model 3196RC configuration
figuration changes will be lost if the power to the Model 3196RC is
turned off.
figure
23) causes the Model 3196RC to perform a cold restart. When you
Set Factory Default Configuration
information, the Model 3196RC's Ethernet IP address, and any other
site-specific settings made for your particular installation. You will
have to re-enter the Model 3196RC's Ethernet IP address and net-
mask using the rear panel control port before using the
HTTP/HTML Management pages.
Figure 24. IP Routing Information Page
3 • Configuring the T-DAC for operation
figure
23) clears out the configuration in FLASH and
(figure
23) will delete any routing
(figure
24).
44
Advertisement
Table of Contents
