SMART Board 800ix Configuration and user’s guide Configuration And User's Manual page 83

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
Command
get blue
get cyan
get magenta
get yellow
get videofreeze
get cc
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See Value-based command
methods on page 70 for setting absolute and adjustment commands.
Command
set displaymode [target]
set brightness [value]
set contrast [value]
set whitepeaking [value]
set degamma [value]
set red [value]
set green [value]
set blue [value]
set cyan [value]
set magenta [value]
set yellow [value]
set videofreeze [target]
set cc [target]
N
N O T E
Typically, cc1 displays English (U.S.) subtitles, while cc2 displays other regional languages, such
as French or Spanish, depending on television channel or media setup.
73
Response
blue=[current blue color setting]
cyan=[current cyan color setting]
magenta=[current magenta color setting]
yellow=[current yellow color setting]
videofreeze=[current video freeze setting]
cc=[current closed captioning language setting]
Command target range
=SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
=0 to =100
=0 to =100
=0 to =10
=0 to =3
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=on
=off
=cc1
=cc2
=off
Response
displaymode=[target]
brightness=[value]
contrast=[value]
whitepeaking=[value]
degamma=[value]
red=[value]
green=[value]
blue=[value]
cyan=[value]
magenta=[value]
yellow=[value]
videofreeze=[target]
cc=[target]