Power State Controls - SMART Board 800ix Configuration and user’s guide Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58

Power state controls

These commands put the projector in and out of Standby mode and request the projector's current
power state. The projector's power state determines whether certain commands are available at that
time. These settings are available even when the projector is in Standby mode.
Command
on
off
off now
off low power
get powerstate
The following table describes the power state commands:
Command
on
off
off now
off low power
get powerstate
The following table describes the power state fields:
Field
Powering
On
Cooling
Confirm off
Idle
71
Response
powerstate=[field]
powerstate=[field]
powerstate=[field]
powerstate=[field]
powerstate=[field]
Description
Turns on the projector.
Starts the shutdown process. A dialog box appears with the
message, "Press Power Button to Turn off Projector." You must send
a second Off command within 10 seconds to put the projector into
Standby mode.
Shuts down the projector immediately. You can't delay or cancel this
command.
The device's current power state. Different devices have different
potential power states. These power states should match the power
states found in the attached projector.
Indicates the projector's current power state.
Description
The projector is turning on.
The projector is on.
The projector is cooling.
Confirm off is a non-selectable power state that is returned during
stage one of the two-button Off sequence.
The projector is off but still receiving power (Standby mode).