To Install Front And Back Rails; To Unlock/Move The Rails - Craftsman 315.218291 Operator's Manual

TO (NSTALL FRONT AND BACK RA(LS
See Figures 13- 14.
[] Loosen the front rail clamps one half turn from the
tightened position. Loosen the square rail holder nut
approximately one-fourth (1/4) turn to allow the front
rail to slide over the nut.
[] Mount the front rail with the scale facing the outside
toward the operator.
[] Check to make sure the rail clamps will securely clamp
the rail before sliding the entire assembly into position.
If not, tighten the square rail holder nut approximately
one-fourth (1/4) turn and recheck.
[] Slide the rail into desired position over both clamps
and secure.
[] Mount the rear rail, following the same clamping
procedure as shown for the front rail.
TO UNLOCK/MOVE THE RAILS
See Figure 15.
The front and back rails will need to be positioned so they
do not touch the floor when the leg stand is closed.
Using the bottom scale as a guide, the scale will need to
be aligned to the saw blade at the 14 in. mark. To unlock
and move the rails:
[] Loosen the front rail clamps by pushing the lever to the
left.
[] Slide the rail to the desired position.
[] Secure the rail in position by pushing the clamp to the
right.
[] Repeat above steps with the rear rail placing it in the
same location as the front rail.
NOTE: When the rails are moved to the right, use caution
to avoid tripping on the front leg brace.
FRONT
RAIL
i i
SQUARE BAiL
HOLDER NUT
FRONTBAIL
CLAMP
Fig. 13
Fig. 15
REAR
RAIL
SQUARE BAiL
HOLDER NUT
BEAR BAIL
CLAMP
Fig. 14
19