To Install Guide Fence Brackets; To Install Post, Guard/Dust Cover With Pivot Assembly - Craftsman 315.218291 Operator's Manual

iNSTALL T-NUTS FROMBEAROF HiP FENCE
T-NUT
Fig. 60
TO INSTALL GUIDE FENCE BRACKETS
See Figure 61.
[] To install the guide fence brackets, align each bracket
with two of the T-nuts on top of the rip fence.
NOTE: Use the front two T-nuts and the back two
T-nuts leaving the one in the middle empty.
[] Secure the guide fence brackets to the rip fence with
5/16 in. washers and the 5/16 in. x 1/2 in. knob bolts.
TO iNSTALL POST, GUARD/DUST COVER WITH
PIVOT ASSEMBLY
See Figure 61.
The guard/dust cover must be used in all routing opera-
tions.
[] Place the spacer on the threaded end of the post and
thread the post into the remaining T-nut.
[] Tighten the post securely with an adjustable wrench on
the flats on the top of the post.
[] Place the guard/dust cover with pivot assembly on the
post.
[] The assembly will slide up and down on the post as
needed. Secure at the desired location by tightening
the knob nut attached to the carriage bolt.
GUARD/DUSTCOVERWITH
PIVOTASSEMBLY
KNOB
CARRIAGE BOLT
NUT NOT SHOWN),_
FLATS ON ®
KNOB
POST_
BOLTS POST----------_ !
U
WASHERS
GUIDE FENCE
BRACKET
T-NUTS
SPACER
RIP FENCE
Fig. 61
42