To Install Bevel Handle Assembly - Craftsman 315.218291 Operator's Manual

Standfacingthebackofthetablesaw. T helongest p artof
themitertablebasemustbestoredto the left.Tosecure
theslidingmiter table:
[] Rest t heslidingmitertableonthe bottomright-hand
storage hookandthe miterbaseonthelowerbottom
left-hand hook.
[]
[]
Align the bottom miter locking clamp with the bottom
left storage hook. Push the sliding miter table back
toward the cabinet until it is resting against all two
hooks.
Lock the miter locking clamps on the left by pushing
clamps toward the side of the cabinet securing the
miter table in place.
MITER
LOCKING
CLAMP
STORAGE
HOOK
TO iNSTALL BEVEL HANDLE ASSEMBLY
See Figure 12.
[] Lift the end cap off the bevel handle assembly using a
flat blade screwdriver.
[] Hold the hex nut securely and turn the screw
counterclockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle or
the washer from the end of the screw.
[] Place the hex nut into the recessed hole on the back of
the height adjusting handwheel and hold in place.
[] Slide the handle, screw, and washer into the hole on
the height adjusting handwheel.
[] Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
[] Push the end cap back in place on the end of the
handle.
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
HEX NUT
BEVEL
HANDLE
%
WASHER
END CAP
>-J
SCREW
Fig. 12
MITER
BASE
STORAGE
HOOK
SLiDiNG MITER
TABLE
Fig. 11
18