Accessory Table Usage; Table Clamping Bracket; To Install T-Nuts For Guide Fence Brackets - Craftsman 315.218291 Operator's Manual

ACCESSORY TABLE USAGE
This accessory table has been specifically designed for
use with some Craftsman Routers. The hole pattern on
the accessory table has not been drilled to accommodate
all routers. Routers must not exceed 3 HP (maximum
developed) or weigh more than 12-1/2 Ibs. Routers must
have lock-on switch feature.
TABLE CLAMPING BRACKET
See Figure 58.
The lever on the accessory table will tighten the table se-
curely to the front rail. The weight of the router may cause
the accessory table to loosen or have movement at the
rear of the table. To avoid this, install the table clamping
bracket.
NOTE: Position the table clamping bracket so that the
accessory table is centered over it.
[] Pull off the end cap from the rear rail.
[] Slide one of the T-nuts into the front channel of the rear
rail and under the accessory table.
[] The table clamping bracket fits in the bottom slot of
the rear rail and the slotted top of the bracket wraps
around the raised portion on the underside of the
accessory table.
[] Secure with a 5/16 in. washer and a 5/16-18 x 3/4 in.
knob bolt.
[] Tighten the knob bolt securely.
[] Reinstall the end cap by pushing it back into the rear
rail.
TABLECLAMPINGBRACKET
SHOWNCOMPLETELY
ASSEMBLED
ACCESSORY
TABLE
TABLE
CLAMPING
BRACKET
T-NUT END
CAP
WASHER
KNOBB0_
Fig. 58
RiP FENCESHOWNLOCKED AGAINSTSAW BLADE
T-NUTBETWEEN
ADJUSTMENT SCREWS
REAR
ADJUSTMENT
SCREW
WASHER
Fig. 59
TO INSTALL T-NUTS FOR GUIDE FENCE
BRACKETS
See Figures 59 - 60.
[] Place rip fence against blade and lock in place.
[] Using the appropriate hex key supplied with your table
saw, remove the rear adjustment screw and washer on
top of the rip fence.
[] Slide one of the T-nuts into the top channel of rip fence
and place between the two adjustment screws.
NOTE: T-nuts install from the rear of the rip fence.
[] Replace the washer and the rear adjustment screw and
tighten securely.
[] Check the rip fence for squareness with the saw blade.
[] Unlock the rip fence, slide it away from the saw blade,
and lock it in place.
[] Slide the four remaining T-nuts into the top channel of
rip fence.
NOTE: Five T-nuts should be in the top channel of
the rip fence with only one of them between the
adjustment screws on the rip fence.
41