Table of Contents
Advertisement
UNPACKING
This product requires assembly.
[] Carefully lift saw from the carton and place it on a level
work surface.
NOTE: This tool is heavy. To avoid back injury, keep
your knees bent and lift with your legs, not your back,
and get help when needed.
A
WARNING:
Do not use this product if any parts on
the Loose Parts List are already assembled to your
product when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result in
serious personal injury.
[] Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts,
and satisfactorily
operated the tool.
[] The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
[] If any parts are damaged or missing, please call
1-800-932-3188
for assistance.
,&
WARNING:
If any parts are damaged or missing, do
not operate this tool until the parts are replaced. Use
of this product with damaged or missing parts could
result in serious personal injury.
A
WARNING:
Do not attempt to modify this tool
or create accessories not recommended
for use
with this tool. Any such alteration or modification
is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING:
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
A
WARNING:
Do not lift the saw without help. Hold
it close to your body. Keep your knees bent and lift
with your legs, not your back. Ignoring these precau-
tions can result in back injury.
WARNING:
Never stand directly in line with the
blade or allow hands to come closer than 3 in. to the
blade. Do not reach over or across the blade. Failure
to heed this warning can result in serious _ersonal
injury.
A
WARNING:
To avoid serious personal injury,
always make sure the table saw is securely mounted
to a workbench
or an approved leg stand. NEVER
operate the saw on the floor.
TO OPEN THE LEG STAND
See Figures 7- 8.
[] Grasp the grips on the saw table and stand it upright
as shown in figure 7 below.
[] Step on the release lever and pull the grips toward you
at the same time.
[] Once the leg stand is released from the release lever,
ease the leg stand toward the floor by pushing the
grips toward the floor.
[] With your hands on the grips, push the leg stand
towards the ground until the table saw is in an upright
position.
NOTE: The release lever will close over the center
brace locking the leg stand in an upright positon.
GRIPS
SAW
\
BASE
RELEASE
LEVER
LEGSTAND
Fig. 7
16
Hide quick links:
Advertisement
Table of Contents
