Problem Solver; Metal Grease Filters - Monogram ZVC48L2SS Owner's Manual

Ouestions?
Use this
problem
solver!
The Problem Solver
Custom Hood Insert
PROBLEM
FAN AUTOMATICALLY
TURNS ON AND CAN
NOT BE TURNED OFF
FAN DOES NOT
OPERATE WHEN
TURNED ON
FAN FAILS TO CIRCULATE
AIR OR MOVES AIR
SLOWER THAN NORMAL
FAN KEEPS GOING
OFF AND ON
LIGHT WILL NOT STAY
ON HIGH SETTING
THE HOOD CONTROLS
ARE NOT OPERATING
CORRECTLY
SEQUENTIAL PRESSES
OF THE LIGHT OR FAN
BUTTONS WILL
SOMETIMES CHANGE
THE SETTING FROM THE
LOWEST SETTING-TO OFF-
TO THE HIGHEST SETTING,
OR FROM THE HIGHEST
SETTING-TO OFF-TO THE
LOWEST SETTING
WHEN PRESSING THE
POWER ON/OFF BUTTON
TO TURN ON THE LIGHT,
THE FAN COMES ON
INSTEAD
POSSIBLE CAUSE
The Sensor feature will automaticallg turn the fan on at the
MED setting if cooking temperatures become too hot. The fan
will stag on for a minimum of 3 minutes and will then turn off when
temperatures cool to an appropriate level.
A fuse mag be blown or a circuit breaker tripped. Replace fuse or
reset circuit breaker.
The power disconnect switch inside the hood mag be switched off.
Remove the metal grease filters and flip the switch on.
Check to be sure the metal grease filters are clean. Clean the metal
grease filters (see the Metal greose filters section). If cleaning
the filters does not correct the problem, call for service.
The motor is probablg overheating and turning itself off. This can
be harmful to the motor. Check to be sure the filters are clean. If off
and on cgcling continues, call for service.
Use 120 volt, S0 watt halogen bulbs with a GU10 base and make sure
theg are inserted securelg. See the Light bulbs section.
Disconnect power to the hood bg removing the fuse or turning the
circuit breaker off in the home fuse box. Wait 30 seconds to allow the
hood controls to reset and then replace the fuse or move the circuit
breaker back on.
It is normal for the light and fan buttons to cgcle around through the
settings so that gou can easilg set the controls to the desired setting.
For gour convenience, it is normal for the lights and fan to remember
their last setting when gou press the Power On/Off button. If gou
want onlg the lights on, press the "FAN +" (or the "FAN -" ) button until
the fan is off. When gou power the hood up next time, onlg the lights
will function.