Problem Solver - Monogram ZV830 Owner's Manual

30″ chimney vent hood
Table of Contents

Advertisement

Available languages

Available languages

Questions?
PROBLEM
FAN AUTOMATICALLY
Use this
TURNS ON OR INCREASES
problem
IN SPEED AND CAN NOT
solver!
BE TURNED OFF OR
LOWERED IN SPEED
FAN DOES NOT
OPERATE WHEN
TURNED ON
8
The Problem Solver
POSSIBLE CAUSE
• The hood fan will turn on automatically or automatically increase in
speed if cooking temperatures become too hot. The fan will turn off
automatically or decrease in speed when temperatures cool to an
appropriate level. Fan will also turn on automatically when the hood
electronics are too hot.
NOTE: When the automatic fan feature is on, you can set the fan to
a higher setting but not to a lower setting or off.
• A fuse may be blown or a circuit breaker tripped. Replace fuse or
reset circuit breaker.
• The power disconnect switch inside the hood may be switched off.
Remove the metal grease filter and the charcoal filter (if present) and
flip the switch on.
LOCATE ON/OFF SWITCH.
1. Press in to release and lower the filter cover panel at the front.
2. Push the filter latch toward the opening and pull downward
to remove.
3. Remove the charcoal filter, if present.
Press corners
to unlock
4. Reach into the motor compartment and locate the ON/OFF switch
at the front of the opening.
5. Press switch to ON position.
NOTE: If the hood blower needs to be removed for service, use the
disconnect switch for your safety. Press the switch to the OFF position.
Chimney Hood
Filter
latch
Push-button
switch
(horizontal
view from
inside
opening)

Advertisement

Table of Contents
loading

Table of Contents