Advertisement
General
Cleaning
continued)
Figure
1
Remove
uppo_
pOStS
provided
with
spice
rack
,_Attach
To Clean the Spice Rack (some models)
To mount
the rack to the
range
refer
to your
Installation
Instructions.
To Remove
Spice Rack :
1. Remove
all the spices from the spice rack.
2. Lift up on the bottom
of the spice rack to remove
it from the support
posts.
To Clean
Spice Rack:
1. Using a mild dish detergent,
clean the spice rack. Cover stubborn
spots with
an ammonia-soaked
paper
towel
for
30 to 40 minutes.
Cleaners
made
especially
for stainless
steel, chrome
or copper
are also recommended.
2. Rinse with
clean water
and a cloth.
3. Rinse off all cleaners
and wipe dry before
operating
the range. Bluish stains
may result
due to heat combining
with
the cleaning
material;
these stains
cannot
be removed.
To Reinstall
the Spice Rack:
1. Place the spice rack on top of the support
posts. Make sure the top lip hooks
over the top of the support
posts and the side flanges
are around
the side
of the support
posts as shown
in the diagram
in Figure 1.
Changing
Cooktop
and/
or Oven Lights
(some
models)
Be sure
the
range
is
unplugged
and all parts are COOL before
replacing
the
surface
or oven
lights.
Wear
a
leather-faced
glove
for
protection
against
possible
broken
glass.
To Change
the Cooktop
Light
(some
models)
1. Turn power
off at the main source
or unplug
the range.
2. Remove Phillips®
Head screws (2) that secure the light cover and then lift the
light
cover off.
3. Remove bulb by rolling
back and up. Install the new bulb bysliding
down
and
rolling
forward
into place.
4. Re-install
light cover and secure with
Phillips®
Head screws (2).
To Change
the Oven Light
(some models)
On some
models,
the
oven
light
automatically
turns
on when
the
door
is
opened.
Some models
have a switch
located
on the control
panel to turn on the
light. The oven light is located
at the rear of the oven and is covered
with
a glass
shield
held by a wire holder.
The glass shield
must be in place whenever
the
oven is in use.
To replace
the oven light:
1. Turn electrical
power
off at the main source
or unplug
the range.
2. Press wire holder
to one side to release the glass shield.
3. Replace
bulb with
a new 40 watt
appliance
bulb.
4. Replace
glass shield over bulb
and snap wire holder
into place.
5. Turn power
back on again
at the main source
(or plug the range
back in).
6. The clock(if
equipped)
will then
need to be reset. To reset, see Setting
the
Clock
and
Minute
Timer
in this Owner's
Guide.
19
Advertisement
