Advertisement
ece is
in a_fixed
set dis-
the workpiece.
Place
arrower
Nider
p refetto
blade position.
)iil_rip:
the biade is toward the column,
and
th_::motOr is toward the table fronL in-rip is
reCom'_ended
because
this position
allows
i better:visibility
of the workpiece
and your
:::_;ilharidS!uselir_:iip
when you set the blade 1/2
: :_to 16"::from:the
fence.
Out-rip:the
blade is toward the table front,
;/: andthernotor
is toward the column.
Use
:;OutLrip only when you set the blade 16" or
more from i thefence_
infeed and Outfeed refer to sides of the
:blade:
'
infeed:
the side of the blade where the
guard hold down is. Always
start a rip cut
at the infeedside
and push the Workpiece
through
to the outfeed
side.
Ouffeed:
the side of the blade where the
pawls and riving knife are, Never start a rip
cut at the ouffeed
side. This is wrong way
feed. Never put hands on the ouffeed
side
of the blade when ripping because
they
can be pulled back }nto the spinning
blade.
L
Front Fence
Position
Rear Fence
Position
:
/_i ¸
_,i_,i _ ,
In-Rip
Position
Infeed
Side
Outfeed Side
Infeed
Side
Pawls/Riving
Knife
Out-Rip
Position
36
Advertisement
