Advertisement
Assembly
installing
Front
Table
1, Set out:
- front table
- tee nut
1/4 "U-clip
1t4" diam. x 7/8" long cup point set
screw
four 1/4" diam. x 1" long pan head
screws
1/4" dia. x 1-3/4" long pan head screw
five 17/64" I.D. x 5/8" O,D. flat washers
- four 1/4" Iockwashers
- four !/4" diam. hex nuts
2. Identify top and bottom of table: top has
counterbored
holes. Place table bottom side
up on solid surface.
Hammer tee nut into lev-
eling hole. (This hole is not counterbored
from the top).
Tee Nut
(install
from
bottom)
O
©
O
©o
O
@
O
' SO
_To
Mounting Holes
Table
p of Table
(Counterbored Holes Up
3, Slide a U-Clip onto the center channel of
the saw as shown.
4. Place the front table on the saw so that
the mounting
holes
in the table line up with
holes
in the table supports
and center chan-
nel of saw.
5. Drop a flat washer
into each counter-
bored hole.
6. Start 1-3!4" long pan head screw through
center hole and into U-clip, but do not fully
tighten.
7. Start cup point set screw through leveling
hole and into tee nut, but do not fully tighten.
8. Put 1" long pan head screw in each of
four remaining
holes and through
matching
holes in table supports.
On end of each
screw, put lockwasher
then nut and tighten
with screwdriveT.
Bolt\
Washer,
Lockwasher
Hex Nut
Set Screw
Leveling Hole
Mounting
Holes
t5
Advertisement
