Advertisement
. :
H
beyond
the trim caps.
9.
Start the mounting
screws into the U-
clipsusing
a Phillips
screwdriver.
Tighten the
screws
untitthe
heads
are just touching
the
table.-Make
sure that the table is not squeez-
_ing the rubber
grommets.
i=i=01 Start the leveling
screws into the level-
ling holes using a: 1/8 inch hex "U' wrench.
Tighten the screws
until they are flush with
the table.
' .... 1i !. Fr0m:ti_e underside
of the table attach
the tabie rails::tothe
table board using the
two holes nearest
the end of each rail.
Leveling
Front Table
NOTE: The goal of this adjustment is to
make the front work table flat and pa ra!lel to
the radia/arm.
In order to do this, you will
choose four points on the table. When these
four points are level, the entire tab/e should
be level.
1. Loosen the three leveling screws andbe
sure that the five mounting
screws are snug
but not overtightened.
2. Raise the radialarm
uatil the bottom of
the motor is about
2-1/2 inches above the
front table.
18
• _
Mounting
Mounting
Hole
._"
/
Holes
_"
Front Table on Front Edge
Advertisement
