Advertisement
roSscutting
..k ng Cro.c.t,
Follow these steps to make crosscuts.
= f=:iPrepare table:
*:put fencein
front position
-tighten
_bte clamps
2, Prepareblade-
, los
motor in :crosscut position
- lock radial arm at desired
miter angle
-lock motor at desired bevel angle*
- unlockcarriage
lock and push blade to
rearmost
position, behind fence
lower blade into kerf* but not touching
kerf bottom (blade should move freely).
* raise Clear plastic guard before changing
bevel angle and when lowering beveled
blade, otherwise
# may jam into table.
3. Position workpiece
against fence, and
lower pawls or riving knife to clear fence or
workpiece,
whichever
is higher, by 1/4".
4_: Grasp saw handle
then turn saw on.
Keep one hand on saw handle through
Step 7.
5: Hold workpieCe down and against fence.
piece._ Pull blade through workpiece but only
far enough
complete
cutl and never more
than ha!f the diameter of blade.
7, Push blade carriage to rearmost
position,
behind fence, and turn saw off. Keep hand
on saw handle until blade stops spinning.
34
Advertisement
