Advertisement
Assembly
13, Using the two #8 x 3/4 pan head screws
provided, attach the new handle in the same
way" as the old one was removed.
14. Inspect motor support cone on yoke, and
cone on motor for lubrication
on contacting
surfaoes.
These surfaces
should be gener-
ous]y lubricated.
If necessary
lubricate with
lithium white grease
(not supplied).
15. Reinstall
motor on motor support.
Line
up the index pin with the slot inthe index
plate. Reinstall
the .505 × 7/8 x 1/t6 washer
and 1/2-13 iocknut.
Take care not to drop
washer in opening of motor. Tighten nut until
the bevel lock lever will lock the motor in any
position when in the lock position.
With the
bevel fock lever in the unlocked position
move the motor to any of the five index posi-
tions.
If motor does not index securely, the adjust-
ment is too loose.
_Caution:
On electronic
models
be
sure bevel control
unit is engaged
with
motor
index
plate
before
installing
washer
and lock nut.
16. Reinstall
the motor support cap.
Unit
Lubricate Cone & Motor
At Point of Contact
,_,,,,,,,,,,,,.,
,,,,, ,_......
23
Advertisement
