Advertisement
_i,washers.
Put the bolts through
the center of
i theer_larged
holes in the
table
supports
so
that the supports
may s_ide
up or down as
needed,
Put a Iookwasher
and
hex nut on
each bott and hand tighten.
NOTE: The goat in adjusting
the table supports
and leveling the front table
is to make sure that
the table is the same distance
from the radial
arm at atl points. This ensures
that when the
table and blade are installed
the clearance
:
between them wit! be equal
at al! points.
P°siti°nmg-
Table
Supports
I. Release
bevel lock lever,
move
bevel index
lever to the left and rotate
the
motor to posi-
tion arbor shaft down.
Lock
lever
lock.
2. Unlock
and hold miter/arm
lock lever in
index release
position
as shown.
Position arm
against
left stop (approximately
50 ° miter).
Loosen:carriage
lock knob
(rip
Iock) and posi-
tion arbor.= shaft directly
over
left hand table
..... support!
,.
3, Slide the arbor:wrench
handle
between
endof
motor :shaft and table
support
to act as
"
afeelergauge_iCarefully
tower.the
motor with
elevation:crank::untii:the
_: e nd
of shaft is just
touching
thearborwrenChl
The
wrench
should
slide back and forth
with
only slight
res0stance. Tighten
screw
A .....
NOTE: Do not: change
this
elevation
setting
until both left and right hand'
table
support
channels
have ben adjusted.
4. Move arm and carriage
to screw
"B".
Adjust position
of table
support
so that the
arbor wrench
just slips between
the end of
the motor shaft and the support.
Tighten
screw "B"
5. Move arm and carriage to right ha_
table sup-
port and level in the same manner
as in step 4.
6. Recheck
both support
channels
to make
sure that tightening
screws
did
not affect the
accuracy
of the adjustment.
7. Elevate the saw and
return
motor to hori-
zontal position
to provide
clearance
for instal-
lation of front work table.
Table Support
I
Screws
_F/at
Hex Head
Bolt
fLockwasher
Nut
Support
/
t
o(T-'-_c--"_o
Front
Mount Support
Using These Holes
Arbor Wrench
Screw "A"
Wrench
Screw "B"
Table Support
14
Advertisement
