Advertisement
Assembly
ii_::!tnstaii:: Fence,
Rear:Tables,
andTable
:::3.; Repeat steps for other table clamp.
4:. Tighten thumbscrews
to clamp table sec-
tions in place,
(Steps 2; 3 and 4 only apply to models with
40" wide table boards.)
, : ln ta.Guard
The guard is a Very important:safetyl
feature::
it covers
a::!Arge part:of the: btade and:h:eips
protect
against
severe cuts: Alwaysuse
the
guard
1. Lock motor at 0 ° bevel (blade vertical).
2. Use one hand to lift clear plastic guard;
use other hand to grasp rear of guard (below
dust elbow).
Position
guard so riving knife
faces front of saw.
3. Tilt front of guard down about 45°; place
over blade; rotate guard to level position,
NOTE:
Make sure notch in guard fits onto
tab on motor adapter.
This will prevent
movement
of guard about motor.
Squeeze
handle
trigger to make sure it raises clear
plastic
guard,
If it does not, remove
and rein-
stall guard,
making
sure that; trigger
mecha-
nism engages
pull link on guard,
4. Tighten
guard clamp screw.
I ii\
¸¸¸
.....
L
Rear
Table
Advertisement
