Hopper Installation - Craftsman ZTS 7500 Operator's Manual

Figure 6. Install Hopper Top
A. Hopper Top
B. Washers, 1/2
C. Hair Pins
D. Bag Support Holes
E. Clevis Pins
F. Bag Support
HOPPER INSTALLATION
1. Attach the hopper top (A, Figure 6) to the bag support
(F) by inserting clevis pins (E) through the bag sup-
port holes (D) and hopper top (A). Secure with wash-
ers (B) and hair pins (C). Make sure hopper brackets
are to left of bag support brackets.
CONNECTING TUBES
Lower Tube Installation
1. Lift discharge deflector up (E, Figure 7).
2. Place the front hole of the lower chute (A) onto car-
riage bolt (C) as shown. Slide front edge of lower
chute (A) under hinge bracket (G).
3. Place the rear hole of the lower chute (A) onto car-
riage bolt (F) as shown.
4. Secure knob (B) onto carriage bolt (C) as shown.
5. Secure wing nut (D) onto carriage bolt (F) as shown.
Connecting Upper & Middle Tube
1. Slide lower tube (A, Figure 8) into upper tube (B).
Figure 7. Install Lower Tube
A. Lower Chute
B. Knob, 5/16-18
C. Front Carriage Bolt, 5/16-18 x 3/4
D. Wing Nut, 5/16
E. Discharge Deflector
F. Rear Carriage Bolt, 5/16-18 x 3/4
G. Hinge Bracket
Figure 8. Connecting Upper and Middle Tube
A. Middle Tube
B. Upper Tube