Table of Contents
Advertisement
Friedrich PTACAccessories
920-087-02 (9-03)
MODELNUMBER
PXWS
PXGA
PXAA
PXDB
PXSC
PXDR10
PXWE
PXSB
PXCJ
PXDC
DESCRIPTION
WALL SLEEVE G-90 zinc coated steel is prepared in an eleven-
step process, then electrostaticanycoated witha polyester finish
and cured in an oven for exceptional durability. The wall sleeve
is insulated for thermal efficiency. 16" High x 42" Wide x 13¾"
Deep.
GRILLE, standard, stamped aluminium, anodized to resist
chalking and oxidation.
ARCHITECTURAL GRILLS that consist of heavy-gauge
6063-i5 aluminium alloy:
Clear, extruded aluminium or dark bronze acrylic enamel
Also available in custom colors.
CONDENSATE DRAIN KIT Attaches to the bottom of the wall
sleevefor internaldraining ofcondensate or to the rear wall sleeve
fiangefor externaldraining. Recommended on all units to remove
excess condensate. Packaged in quantities often.
DEEP WALL SLEEVE EXTENSION A four inch deep anodized
aluminium extensionthat attaches to the outside of thewall sleeve
when the wall is greater than eleven inches thick (9½" when a
subbase is used, 10 inches when a lateral duct is used).
DECORATIVE SUBBASE Provides unit support for wans less
than six inches thick. Includes leveling legs, side filler panels
and mounting brackets for electrical accessories. Accepts
circuit breaker, power disconnect switch, or conduit kit.
CONDUIT KIT WITH JUNCTION BOX Hard wire conduit kit
with junction box for 208/230V and 256V units (subbase not
required). Kit includes a means of quick disconnect for easy
removal of the chassis. *Required for 265V installations.
DESK CONTROL KIT A field installed kit which allows the
unit to be turned on or off from a remote central station via
a 24V interface.
PHOTO
PXWS _
/
PXDB
PXDR1O
PXCJ
PXDC
RT2
DIGITAL REMOTE
THERMOSTAT
A Honeywell wall
mounted remote thermostat.
Requires proper P-Series
chassis.
RT2
22
Advertisement
Table of Contents
