Craftsman 152.219110 Instruction Manual page 23

SUPPORTING WORKPIECE
USE only recommended accessories,
Figure 17-1
o
o
A
IMPORTANT: When the workpiece (A) is long enough,
position it on the table with one end against the left side
of the column (B) to prevent the workpiece from rotat-
ing, See Figure 17ol, if it is not possible to support the
workpiece against the column, clamp the workpiece to
the table, A vise can be used to secure a small work-
piece that is too small to be clamped to the table, The
vise must be secured to the table to keep it from rotat-
ing, if you are using a backup board, it must also be
properly supported or clamped,
QUILL LOCK
The quill allows the up and down movement of the
chuck, Different setup or working operation may
require the quill to be lower and locked into position,
Figure 18-1
C
B
Lower quill (A) to desired depth and tighten quill locking
handle (B), The quill locking handle is spring loaded
and can be repositioned by pulling out on the hub (C)
and rotating it, See Figure 18-1,
To unlock the quill, hold onto the feed handle and
loosen the quill locking handle, The quill is spring
loaded and wiii return back up into the drill press head
casting, Be sure to hold onto the feed handle to control
the speed in which the quill returns,
23