Craftsman 152.219110 Instruction Manual page 14

DRILL PRESS HEAD AND
MOTOR ASSEMBLY
* The drHU press is a heavy machine; two peopb may
be required for certain assemMy operations,
* MAKE CERTAIN the drHU press is disconnected from
the power source,
Figure 5-1
A
Figure 5-3
G
\\
\
B
1, Seat the drHU press head (A) on the coUumn (B),
See Figure 5-1
Figure 5-2
i !
, C
H
F
3, Thread the three feed handbs (F) in the three
tapped hobs (G) bcated in the pinion shaft (H),
Figure 5-4
2,
Align the drill press head with the table (C) and
base (D) and tighten the two head locking screws
(E), See Figure 5-2,
NOTE: Make certain that the spindle taper (I) and the
tapered hob in the chuck (J) are clean and free of
grease, lacquer, or rust preventive coatings, See
Figure 5-4 Household oven cleaner can effectively
remove any substance from the spindle and chuck,
Carefully follow the manufacturer's safety rubs
concerning its use,
14