Craftsman 152.219110 Instruction Manual page 12

TOOLS REQUIF{EB
The following toob are needed for assembly and align-
ment, Note: Two hex wrenches (3mm and 4mm) are
provided, The remaining tools are typbal shop toob and
are not included with your drill press,
12ram Open end wrench Hammer and block of wood
13ram Open end wrench Combination square
#2 Phillips screwdriver
Figure 4-2
The drill press is a heavy machine; two people may
be required for certain assembly operations,
DO NOT assemble the drill press until you are sure
the tool is unplugged,
DO NOT assemble the drill press until you are sure
the power switch is in the "OFF" position,
For your own safety, DO NOT connect the drill press
to the power source until the machine is completely
assembled and you read and understand the entire
instruction Manual,
COLUMN, BASE and TABLE ASSEMBLY
J
H
3, Place the worm gear (G) in the table bracket (H),
See Figure 4-2,
Figure 4-3
Figure 4-1
B
C
NOTE: Place the small end of the worm gear (I)
through hob (J), in the table bracket, See Figure 4-2,
The correct placement is shown in Figure 4-3,
Figure 4-4
2,
Attach the column (A) to the base (B) using the four
M8x1,25x25mm hex head screws (C), two of which
are shown, See Figure 4-1,
Loosen the set screw (D) and remove the ring (E)
and rack (F),
4, insert the rack (F) in the table bracket groove (K),
See Figure 4-4,
NOTE: Place the teeth of the rack (L), see Figure 4-4 in
the teeth of the worm gear inside of the table bracket,
12