Craftsman 152.219110 Instruction Manual page 17

* DONOTexpose theddH pressto rainoroperate the
in dampbcations.
* MAKESUREaHpartshavebeen assembbd correctly
andarein working order.
SWITCH OPERATION
Figure 8-1
FLEXIBLE LAMP
To reduce the risk of fire, use 40 watt or bss, 120 voUt,
reflector track-type Hght buUb(not supplied). DO NOT
use a standard househoUd Hght buUb. The reflector track-
type Hght buUbshouUd not extend bebw the Uampshade.
Figure 9-1
B
The switch (A) is bcated on the front of the ddH press
head. See Figure 8-1. To turn the ddH press ON, move
the switch up. To turn the ddH press OFF, move the
switch down.
Figure 8-2
B
\ \\\
\\\
\ \\
\
IMPORTANT: When the machine is not in use, the
switch shouUd be bcked in the OFF position to prevent
unauthorized use.
1. Grasp the switch toggle (B) and pull it out of the
switch. See Figure 8-2.
2. With the switch toggle removed, the switch will not
operate. However, should the switch toggle be
removed while the drill press is operating, the
switch can still be turned OFF, but cannot be
restarted without inserting the switch toggle.
The flexible lamp (A) operates independently of the drill
press, but uses the same power cord, To turn the lamp
ON and OFF, rotate the switch (B) in the clockwise
direction only, See Figure 9-1,
CAUTION: The flexible lamp housing will remain hot for
a few minutes after turning it OFF, Avoid contact with
housing until it is cool,
TABLE OPERATION
Figure 10-1
C
1, To raise or lower the table (A) on the column (B),
loosen the table lock handle (C), See Figure 10-1,
17